XC80

XC80
ESTIMATED PRICE*
PRICE RANGES: Price reflects the most common average installation cost in your area based on a 3 ton unit. Price ranges shall apply to basic installation. All price ranges are subject to adjustment based on the unique characteristics and location (i.e. zip code) of the home. Any changes or modifications to Basic Installation agreed upon by Buyer will be an additional cost as negotiated by Buyer and the independent Trane Comfort Specialist™ including ductwork. See more details
No Information
Pricing and specialist vary by location
Valid zip code not detected
Change your ZIP code for new results.
Please enter a valid zip code
Our
communicating high efficiency units Indoor and outdoor sensors allow the thermostat control to determine and communicate exactly how much heating or cooling, dehumidification or humidification and air flow are required to keep the home optimally comfortable.
must be installed with another communicating high efficiency unit. If you do not currently have a communicating high efficiency setup you will need one of the following communicating high efficiency components to pair with the XC80: XV20i TruComfort™ Variable Speed Air Conditioner, XV20i Variable Speed Heat Pump, XV18 TruComfort™ Variable Speed Air Conditioner, or XV18 Variable Speed Heat Pump.

Cost Breakdown

  • Thermostat
    A thermostat is a device that automatically regulates temperature, or that activates a device when the temperature reaches a certain point. A thermostat can either be standard or Wi-Fi connected, either of which is dependent on your individual needs.
    Included
  • Whip
    Whips are wires in a weather proof casing for outdoor use. They are used to connect the 220 volt power to your outdoor unit, in some locations a licensed electrician is required.
    Included
  • Electrical Disconnect
    This service switch permits a service technician to work safely on equipment by turning off electrical power to the unit. The switch is typically on a building wall near the outdoor unit.
    Included
  • Flush existing refrigerant line set or install new line set
    Insulated copper piping which carries the refrigerant (produces cooling effect) from the outdoor unit to indoor unit. The insulation protects any condensation from leaking into your home.
    Included
  • Clean up after installation
    Included
  • Removal and disposal of old system
    Included
  • Install new system by local code
    Included
  • Reconnect to existing ductwork
    Connect to existing ductwork (conduits or passages used in heating, ventilation and air conditioning to deliver and remove air. Air ducts ensure acceptable indoor air quality as well as thermal comfort *)

    * Does not include any new ducts that may be needed for your specific home needs
    Included
  • Standard 1 (one) year Labor Warranty
    Included
  • 5 (five) year Equipment Parts Warranty (coil and compressor only)
    Included
Heating Stages
Units with multiple heating stages have more precise temperature control and operate more efficiently than single stage units.
Two-stage

XC80 DESCRIPTION

Gas Furnace

XC80

ESTIMATED PRICE*
PRICE RANGES: Price reflects the most common average installation cost in your area based on a 3 ton unit. Price ranges shall apply to basic installation. All price ranges are subject to adjustment based on the unique characteristics and location (i.e. zip code) of the home. Any changes or modifications to Basic Installation agreed upon by Buyer will be an additional cost as negotiated by Buyer and the independent Trane Comfort Specialist™ including ductwork. See more details
No Information
Pricing and specialist vary by location
Valid zip code not detected
Change your ZIP code for new results.
Please enter a valid zip code
Our
communicating high efficiency units Indoor and outdoor sensors allow the thermostat control to determine and communicate exactly how much heating or cooling, dehumidification or humidification and air flow are required to keep the home optimally comfortable.
must be installed with another communicating high efficiency unit. If you do not currently have a communicating high efficiency setup you will need one of the following communicating high efficiency components to pair with the XC80: XV20i TruComfort™ Variable Speed Air Conditioner, XV20i Variable Speed Heat Pump, XV18 TruComfort™ Variable Speed Air Conditioner, or XV18 Variable Speed Heat Pump.

Cost Breakdown

  • Thermostat
    A thermostat is a device that automatically regulates temperature, or that activates a device when the temperature reaches a certain point. A thermostat can either be standard or Wi-Fi connected, either of which is dependent on your individual needs.
    Included
  • Whip
    Whips are wires in a weather proof casing for outdoor use. They are used to connect the 220 volt power to your outdoor unit, in some locations a licensed electrician is required.
    Included
  • Electrical Disconnect
    This service switch permits a service technician to work safely on equipment by turning off electrical power to the unit. The switch is typically on a building wall near the outdoor unit.
    Included
  • Flush existing refrigerant line set or install new line set
    Insulated copper piping which carries the refrigerant (produces cooling effect) from the outdoor unit to indoor unit. The insulation protects any condensation from leaking into your home.
    Included
  • Clean up after installation
    Included
  • Removal and disposal of old system
    Included
  • Install new system by local code
    Included
  • Reconnect to existing ductwork
    Connect to existing ductwork (conduits or passages used in heating, ventilation and air conditioning to deliver and remove air. Air ducts ensure acceptable indoor air quality as well as thermal comfort *)

    * Does not include any new ducts that may be needed for your specific home needs
    Included
  • Standard 1 (one) year Labor Warranty
    Included
  • 5 (five) year Equipment Parts Warranty (coil and compressor only)
    Included
Communicating technology for the ultimate comfort and greater efficiency. The advanced ComfortLink™ II allows the XC80 to constantly configure itself for optimal performance year after year.

More Details

TOTAL ESTIMATED INSTALLED PRICE *Estimated price reflects the most common average installed cost across the USA. Price may vary in your area. See more details

Overview

-

Efficient performance

The XC80 two-stage furnace is rated with up to 80% AFUE.

ComfortLink™ II Communicating Capability

ComfortLink™ II communicating technology connects all of your key components so your system automatically charges, configures and calibrates for optimal performance through the lifetime of your products.

Comfortable, even heating

Variable-speed fan motor adjusts speed to provide a consistent flow of warm, comfortable air with quiet operation.

Cleaner, healthier indoor air

Add Trane CleanEffects™ Air Cleaner to your system for advanced air filtration that removes more dust, pollen and other irritants from conditioned air for a cleaner, healthier, more comfortable home.

Product Brochure

Specifications

-

XC80 variable-speed, 2-stage upflow/horizontal furnace models

MODEL NOMINAL TONS AFUE HEIGHT (IN.) WIDTH (IN.) DEPTH (IN.)
TUD2B060ACV32A 3 80.00 40 17.5 28
TUD2B080ACV32A 3 80.00 40 17.5 28
TUD2C080ACV42A 4 80.00 40 21 28
TUD2B100ACV32A 3 80.00 40 17.5 28
TUD2C100ACV52A 5 80.00 40 21 28
TUD2D120ACV52A 5 80.00 40 24.5 28
TUD2D140ACV52A 5 80.00 40 24.5 28

XC80 variable-speed, 2-stage downflow/horizontal furnace models

MODEL NOMINAL TONS AFUE HEIGHT (IN.) WIDTH (IN.) DEPTH (IN.)
TDD2B060ACV32A 3 80.00 40 17.5 28
TDD2B080ACV32A 3 80.00 40 17.5 28
TDD2C100ACV52A 5 80.00 40 21 28
TDD2D120ACV52A 5 80.00 40 24.5 28

Every Trane gas forced air furnace is packed with high-quality components. Each helps ensure that time after time, your unit will provide total comfort your family can rely on. The XC80 two-stage furnace includes:

  • ComfortLink™ II communicating capability
  • Communicating user interface
  • Variable-speed blower motor
  • Two-stage gas heat
  • Heavy gauge, two-tone powder-painted cabinet
  • Increased dehumidification with Comfort-R™
  • Durable silicon nitride hot surface igniter
  • Multi-port, in-shot burners
  • One-piece aluminized steel heat exchanger with no welds
  • 24-volt fuse to protect controls
  • Insulated cabinet for quiet operation
  • Convertible to horizontal, left or right
  • Compatible with ERV, humidifier and air cleaner

Trane Warranty

Protect your XC80 with one of our top of the line warranties

View Warranty 

Contact a local Trane Comfort Specialist™

WANT TO SAVE ON A NEW SYSTEM?
NEED EMERGENCY REPAIRS?

WE CAN HELP

Let us know how we can help and the top-rated Trane Comfort Specialist™ in your area will contact you shortly.

By pressing the “Submit” button, I consent to receive a phone call about products and services from a Trane Comfort Specialist™ at the phone number(s) provided. I understand these calls may be generated using automated technology and my consent does not imply or require that a purchase be made.
  • Weather for

    Charlotte

    92°

    Clear Sky

Still have questions?

Here's what your dealer can do for you

  • Custom evaluation
  • Local rebates
  • Expert repairs
  • Upfront pricing

*PRICE RANGES

Price ranges shall apply to basic installation to include standard materials and service, which may vary by the type of system or unit selected. All price ranges are subject to adjustment based on the unique characteristics of the home. Any changes or modifications to Basic Installation agreed upon by Buyer will be an additional cost as negotiated by Buyer and the independent Trane Comfort Specialist™, including the cost of mechanical permits that may be required by local and state law. Price ranges do not include any taxes, now or hereafter enacted. Taxes will be added by your Trane Comfort Specialist™ to the sales price to comply with local and federal tax law.

Basic installation varies slightly based on the type of system, unit or accessory purchased.

AC Furnace & Air Handler Split and Packaged Systems: Materials & Services - Install new condenser pad, an A/C whip, with electrical disconnect switch, either flush existing refrigerant line set or install new line sets (determined by placement in home); includes the removing and hauling away of the old system or unit, installing new system or unit by local code, installing new thermostat, reconnecting to existing ductwork.

Mini-Split Systems: Materials & Services: Install new condenser pad, electrical wiring, either flush existing refrigerant lineset or install new line sets (determined by placement in home) and a remote control; includes the removing and hauling away of the old system or unit, installing new system by local code, connect electrical to new unit.

Accessory installation: Materials & Services - electrical wiring; includes the removing and hauling away of the old system, installing new system by local code, connect electrical to new unit.

Standard Warranty: Standard Labor (One (1) Year XR Series, Two (2) Years XL/XV Series) & Parts Warranty (5 Year Unregistered or 10 Year Registered). Longer warranty terms are available. Please contact your independent Trane Comfort Specialist™ for details.